Quadro SW-Version 4.1.x Guía de instalación descargar pdf (Pagina 52)

QuadroISDN Manual II: Administrator's Guide Administrator’s Menus

QuadroISDN; SW Version 4.1.x 52

PSTN Lines Sharing

PSTN Lines Sharing page is used to configure QuadroISDN to act as an ISDN expansion device for the remote Quadro IP PBX, i.e. to share its

ISDN trunks to the master Quadro IP PBX. This provides Quadro IP PBX a possibility to call not only through local ISDN lines but also through

available shared ISDN lines on the QuadroISDN.

When sharing mode is enabled, the ISDN Settings page becomes read-only on QuadroISDN and corresponding routing patterns are automatically

created in the

Call Routing table.

• The configuration of all ISDN trunks on the QuadroISDN will become transparent to Quadro IP PBX upon enabling the sharing mode.

• Independent of the configuration on the QuadroISDN, the incoming calls on all shared ISDN trunk will be automatically routed to the

default Auto Attendant (00) once ISDN sharing is activated. Occasionally, routed destinations can be then changed on Quadro IP

PBX.

• Any changes applied to the configuration of shared ISDN lines on the Quadro IP PBX will be automatically reflected in the ISDN

Settings page and Call Routing table on the QuadroISDN.

PSTN Lines Sharing page consists of the following

components:

The Provide PSTN lines for master device checkbox is used

to share the existing ISDN lines to the remote Quadro.

Username and Password text fields are used to enter the

identification parameters for the authentication on the remote

Quadro IP PBX. In its turn, these authentication settings should

be added in the Authorization Parameters table on the master

Quadro IP PBX.

Master device IP text field requires the IP address of the

master Quadro current ISDN trunks will be shared for.

Master device port text field requires the port number of the

master Quadro current ISDN trunks will be shared for.

Registration State and Registration Date/Time fields indicate

read-only information about the last successful registration on

the master Quadro (i.e. when authentication was successful), its

state and the registration date/time.

Fig. II-92: PSTN Lines Sharing page

Gain Control

The Gain Control settings are used to define transmit and

receive gains. For ISDN lines, Transmit Gain defines the level

of voice transmitted from Quadro to the PSTN network and

Receive Gain defines the volume of voice received by Quadro

from the PSTN network.

The Gain Control page offers Transmit Gain and Receive

Gain drop down lists for each line that contains allowed gain

values, which can be set up by the administrator for every line.

Please Note: If the gain control has been configured incorrectly,

DTMF digits may not be properly recognized. Gain control

settings are strictly dependent on the location (country) of

Quadro and the phone type.

The Restore Default Gains button restores the default values.

Fig. II-93: Gain Control page

Call Routing

The Call Routing service simplifies the calling procedure for Quadro users, i.e., different types of calls (internal, SIP, ISDN or IP-PSTN) can be

placed in the same way. SIP registration is not needed for extensions to make routing calls.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 105 106

Comentarios a estos manuales

Sin comentarios

Quadro SW-Version 4.1.x Guía de instalación Pagina 52

Comentarios a estos manuales

Relacionado con productos y manuales para Sistemas premisa branch exchange (pbx) Quadro SW-Version 4.1.x