Quadro SW-Version 4.1.x Guía de instalación descargar pdf (Pagina 27)

QuadroISDN Manual II: Administrator's Guide Administrator’s Menus

QuadroISDN; SW Version 4.1.x 27

Diagnostics

The System Diagnostic page gives a possibility of running Network and WAN protocol diagnostics to verify Quadro's connectivity and to download

all system logs for possible problems recovery.

The Start Detecting WAN Protocol button is used to initiate WAN diagnostics that will detect the WAN IP configurations: static or through DHCP

and PPP servers. For static WAN IP configuration, gateway availability is checked. When acting as a client, DHCP and PPP servers' accessibilities

are being verified.

The Start Network Diagnostics button is used to initiate network

diagnostics, i.e., to check the WAN link and IP configuration, to

verify gateway, DNS primary and secondary (if configured) servers'

accessibilities.

The Start ISDN Diagnostics button is used to initiate ISDN BRI

low level diagnostic. With these tests the ISDN physical link is

checked and the Frame Synchronization is verified.

The field below will display the diagnostics results and the

connectivity conditions. The system should be reconfigured if

problems occur during the diagnostics.

The Download system logs button is used to download all logs to

the local PC as a *.tar archive file. These logs can then be used by

the Epygi Technical Support Office to determine the problem that

has occurred on your Quadro.

The Reboot this Device button is used to reboot the Quadro.

Please note that the session with the Quadro will be closed, i.e.,

the Quadro GUI should be newly opened and a new login will be

required afterwards.

Fig. II-44: System Diagnostic page

Automatic Provisioning

Automatic Provisioning provides the possibility to automatically

configure the WAN network settings of Quadro. This is very useful

when the administrator is not actually aware about the Quadro’s

network settings. Automatic Provisioning automatically detects

the matching network configuration settings, applies them on the

Quadro, thus connecting the device to the internet through the

available ISP connection.

Please Note: Automatic Provisioning can only be run from the

LAN side of the Quadro, i.e. from the PC connected to the

Quadro’s LAN.

Automatic Provisioning automatically detects and configures the

following settings on the Quadro:

• WAN interface type (PPPoE or Ethernet)

• WAN IP settings

• PPP settings

• ISP settings

• DHCP settings

• DNS settings

• NAT Traversal settings

Fig. II-45: Auto Provisioning page

Upload Language Pack

Upload Language Pack page allows to upload a custom language

for GUI and Voice Messages of the Quadro. The language of voice

messages can be switched to the custom Language Pack

language from GUI setting page at the

System Configuration

Wizard

. The language of GUI session can be changed to the

custom Language Pack language from the radio buttons on the

Uploading a Language Pack will cause the loss of the following

data:

• All internally stored voice mail

• DHCP leases

• Call statistics

• Pending events

• Transfer statistics

Fig. II-46: Upload Language Pack page

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 105 106

Comentarios a estos manuales

Sin comentarios

Quadro SW-Version 4.1.x Guía de instalación Pagina 27

Comentarios a estos manuales

Relacionado con productos y manuales para Sistemas premisa branch exchange (pbx) Quadro SW-Version 4.1.x