Quadro Quadro2x2 Guía de instalación descargar pdf (Pagina 44)

QuadroM 32x/8L/26x/12Li/26xi Manual I: Installation Guide Step 2: Configuring the Quadro

Fig. I-48:ISDN Wizard – ISDN PRMP Settings

For MSN service enabled, the Routing Settings page is used to assign MSN numbers to

the certain destinations on the Quadro. The MSN number can be assigned to the Quadro’s

extensions, to the Auto Attendant, or to the routing agent. The destination selected from

this page will ring upon incoming call to the corresponding MSN number comes in.

The fields in the MSN Number column require the MSN numbers allocated to the Quadro.

Please Note: At least one MSN number should be defined in this page. The system dis-

plays an error message if the same MSN number is used twice in this page.

The Route Incoming Call to drop-down lists is used to select the destination where the in-

coming call addressed to the certain MSN number will be routed. Choosing the Routing

with inbound destination number selection will automatically use the initially dialed num-

ber to connect the destination without any additional dialing. If MSN is disabled on the

ISDN Wizard - MSN Settings page, the ISDN Wizard - Routing Settings page contains

only one Route Incoming Call to drop-down list.

Selecting the Use Default outgoing Caller ID allows you to overwrite the source caller in-

formation with the one specified in the Default outgoing Caller ID field when placing out-

going calls toward the CO. The Default outgoing Caller ID field requires the caller ID for

the outgoing calls from the Quadro through the ISDN trunk. That number should be regis-

tered at the CO and can be one of the MSNs provided by the CO. If this checkbox is en-

abled but no value is defined in the Default outgoing Caller ID, empty caller information

will be sent to the CO. If this checkbox is disabled, the source caller information will be for-

warded to the CO.

Select the Advanced Settings checkbox if you wish to adjust trunk L2 and L3 Settings

manually, otherwise leave this checkbox unselected to use the system default values.

QuadroM 32x/8L/26x/12Li/26xi; (SW Version 5.2.x) 44

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 75 76

Sin comentarios

Quadro Quadro2x2 Guía de instalación Pagina 44