Quadro Quadro2x2 Guía de instalación descargar pdf (Pagina 25)

QuadroM 32x/8L/26x/12Li/26xi Manual I: Installation Guide Step 2: Configuring the Quadro

Step 2: Configuring the Quadro

Verify functionality of both IP and PSTN calls:

• PSTN telephony: If the Quadro is connected to the PSTN network via the

E1/T1, FXO or ISDN interface, verify the functionality of PSTN calls:

o Make an outbound PSTN call by dialing 9 + PSTN number.

o Arrange to receive an incoming call. The incoming PSTN calls will be

routed to the Auto Attendant by default, and the caller has to enter a

valid extension number, e.g., 101, followed by the # sign to reach a

phone connected to the first PHONE port of the Quadro.

• IP telephony: Dial 899# and you will hear a voice message that confirms you

have successfully established an IP call. If this call is not successful, go to

Appendix: Checking the Connections

for troubleshooting.

You may customize the following settings by logging in to the Quadro’s Web Management

(see Step 2.1):

• Bandwidth - to regulate the number of calls allowed by the Quadro to avoid

degradation in low bandwidth conditions.

• Time/Date - to ensure the correct time and time zone are used for call records.

• Regional Settings - if your Quadro is located outside the United States, it is

important to properly configure your line connections to the PSTN in your loca-

tion.

• Firewall - if your Quadro is connected behind a router with its own firewall ser-

vice running, disable the firewall to make Quadro accessible for management

purposes.

QuadroM 32x/8L/26x/12Li/26xi; (SW Version 5.2.x) 25

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 75 76

Sin comentarios

Quadro Quadro2x2 Guía de instalación Pagina 25