Quadro SW-Version 4.1.x Manual de usuario descargar pdf (Pagina 14)

QCM Installation Guide Configuring Lines on the QCM

Step 2.2: IP Line Activation

This step is required only if an IP line (not FXS) is attached to the extension. To check whether the

attached IP line is active, follow these steps:

1. Select Line Settings from the Telephony menu.

2. On the Line Settings page, click on the IP Line Settings tab. If the Type parameter for

the corresponding IP line is set to anything but Inactive (see Figure 9), then the line is

already active and the following steps can be skipped.

To activate an IP line, follow these steps:

1. Click the IP line link attached to the configured extension (see Step 2.1

2. On the IP Line Settings page for the selected IP line, specify the following settings (see

Figure 3):

2.1. Select the SIP Phone radio button.

2.2. From the Phone Model drop-down list, select QCM.

2.3. Specify the Username and Password settings. The values for the settings in this

scenario can be arbitrary except that the username should be unique within the

existing usernames for remote extensions and IP lines.

3. Select the Use Session Timer checkbox to enable the SIP session timer for the

corresponding IP line. This option allows user agents and proxies to determine if the SIP

session is still active.

4. Click Save to submit the changes.

Figure 9 IP Line Settings page: IP Line 5 is inactive

Quadro Communications Manager (SW Version 4.1.x)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Quadro SW-Version 4.1.x Manual de usuario Pagina 14