Quadro Quadro4x Manual de usuario descargar pdf (Pagina 3)

IP Phones and IP Lines Configuration for Quadro IP PBXs

1 Introduction

Every Quadro IP PBX (2x, 4x, 16x) provides the possibility to connect IP phones in addition to the

standard FXS phones. The IP phones will be connected via Ethernet to the Quadro LAN port (

Figure 1:

IP Phones and Quadro

) and serve as additional phones similar to the FXS extensions. This document

describes the configuration steps that are necessary to setup both the Quadro and the IP phones. The

scope of this document does not cover specific brands or even vendors of IP phones, but should give a

general overview and a guideline.

Chapter

2 General Information provides some additional information for an IP phone scenario. It gives

answers to general questions. Chapter

3 Configuring the Quadro and Chapter 4 Configuring the IP

Phones

will then describe detailed configuration steps based on this information. The steps shown in

Chapter

3 are illustrated with actual screenshots of a Quadro 4x (running firmware version 3.0.37). 2x

and 4x/16x models are identical concerning the topics covered here. Older or even newer firmware

version might differ slightly in aspect of the GUI.

Figure 1: IP Phones and Quadro

7 November 2005 3

1 2 3 4 5 6 7 8 9 10

Sin comentarios

Quadro Quadro4x Manual de usuario Pagina 3